1) We extrude the first parts under No. 5,6

2) We turn over part No. 6 as shown in the photo.

3) Extrude parts under number 1

4) We install part number 1 into part number 6 as shown in the photo

5) Extrude parts numbered 2 and 3

6) Install part number 2 as shown in the photo and push it to the left side

7) Install part number 3 in the same way and move it to the right side

8) Extrude parts number 9 and install as shown in the photo

9) Then we extrude the set of parts number 4 and install the first part from the set as shown in the photo

10) Install the second part from set number 4 so that the cutouts match

11) We install the second part from set No. 4 so that the number is near the cutout. Important!!! What number will you put next to the cutout! This is the number of clicks it will take to open it, but if you put it where there is no number, then this ring will remain in the zero position

12) Next, in the same way as at the beginning, we alternately install parts number 3 and 2

13) Then we fix them with parts number 7

14) Then install the parts as described in step number 9

15) We repeat step 14 until we reach the top of the cryptex where we need to install the lid, fix the last layer with parts number 8

Then install the cover

The next step is to install the deadbolt number 11

Then install the key number 10

We set all the notches to the zero position, that is, so that all the notches are in the same row, then by scrolling the rings you can hear clicks, counting their number from the zero point, you can set the code that we set at step number 9